 |
|||||||||
 |
Home | About ShoreBest | Cross Reference | ||||||||
 |
 |
 |
 |
 |
 |
 |
 |
||
| New Masonry Cleaners |
Rest- oration Cleaners |
Paint Strippers | Remedial Products | Water Repellents | Environ-mental Products | Concrete Products | EIFS Appearance System |
||
|
2740 Concrete Protective Coating SARC
2740 Concrete Protective Coating SARC is a custom blended, high performance acrylic latex coating for the protection of architectural concrete, concrete block, some metal and wood surfaces. 2740 has been used for waterproofing concrete block when a flexible coating is required to maintain the integrity between the concrete block and the mortar joint. 2740 provides long term protection to concrete surfaces that have had extensive repairs and there is a need for a unifying color or color change. Preparation
Application is to be to clean, dry and sound surfaces. All containers must be mechanically stirred with a Jiffy Mixer that does not allow for air bubble formation. If colors are in use, box several containers together to avoid possible color variation. Prepare enough material to work from a control joint, expansion joint or corner to avoid possible color changes within a work area that does not have a natural separation point. Protect any surface that is not to receive the coating from over spray, dripping or other means of exposure to the coating. An on site application of 5 to 10 square feet of area is recommended to check for color and general appearance acceptance. Allow the test area to dry for 24 hours prior to review.
Application
2740 can be applied by spray, roller or brush using the crosshatch method. If the first coat is applied vertically the second coat must be applied horizontally to provide for an even finished appearance. Two coats are required for any project. Each coat will dry for re-coat within 4 hours at 70 degrees F and 50% humidity. Application of subsequent coats, before the appropriate dry time, can lead to bond failure between the paint films. It is recommended that the first coat be thinned with water and used as a primer coat when application is to an unprimed surface. Clean all equipment with soap and water.
Limitations
Do not apply to a wet surface or when rain is expected with 12 hours. Minimum application temperature is 50 degrees F surface & ambient and rising. Do not apply to surfaces that are above 95 degrees F. Reseal the container after withdrawing material. Do not use coatings that have been frozen and thawed.
Technical Data
Some colors are available in for large quantity projects. Safety
This product must be used only as directed. Safety matters included with product. MSDS available from your regional representative.
Customer Service & Technical Assistance
Factory personnel can be contacted at 800/860-4978 for specific recommendations without any obligation.
Factory trained regional representatives are available to assist with product recommendations for you projects, and many locations are served by dealers who stock ShoreBest products. Call 800/860-4978 for the name and location of your nearest representative or dealer. |
Home | Products | Cross Reference | Warranty | Company | Projects 800.860.4978 | infoproducts@shorebest.com | © 2003 Shore Corporation |