 |
|||||||||
 |
Home | About ShoreBest | Cross Reference | ||||||||
 |
 |
 |
 |
 |
 |
 |
 |
||
| New Masonry Cleaners |
Rest- oration Cleaners |
Paint Strippers | Remedial Products | Water Repellents | Environ-mental Products | Concrete Products | EIFS Appearance System |
||
|
2600 EIFScrub
2600 EIFScrub is a general purpose alkaline cleaner for EFIS surfaces and may also be used for cleaning of adjacent painted metal and vinyl surfaces such as gutters, down spouts, fascia & soffit and most other miscellaneous materials found in EIFS construction. 2600 can also be used for the cleaning of cement plaster, most painted surfaces, architectural concrete and limestone. Dilution ratios are from undiluted to four parts water. Test panels should start every project to determine acceptability and the proper dilution ratio or ratios for various surfaces.
Technical Data
Preparation
Provide protection for foliage and pedestrian traffic. Test all surfaces which
might be exposed to product for possible adverse reactions. Protect all surfaces
and surrounding areas from possible damage which might occur from spillage or
spray during usage.
All projects should start with a test application to determine the suitability of the cleaner, acceptable application method and dilution ratio if applicable. Test areas of at least 10 square feet are recommended and should involve the most severely contaminated condition. When possible, the test area should be left to dry in order to check for any latent reaction that might require a change in methods or products. Application
2600 EIFScrub may be applied by low pressure spray, synthetic fiber brush or
roller. Brush agitation may be helpful on some projects. Dwell times may vary
from five to thirty minutes. Do not allow the cleaner to dry on the surface.
Removal of the cleaner and contamination can be accomplished with high pressure
rinsing equipment. Care should be taken in the selection of the wand tip to
avoid damage to the EIFS surface. In all cases, a thorough rinsing is required.Limitations
2600 EIFScrub is for use by professional contractors only. Projects should not
be undertaken when temperatures are below 50 degrees F. Do not allow the cleaner
to dry on the surface. Misting of drying cleaner is permissible to avoid possible
reapplication. Safety
This product must be used only as directed. Safety matters included with product. MSDS available from your regional representative.
Customer Service & Technical Assistance
Factory personnel can be contacted at 800/860-4978 for specific recommendations without any obligation.
Factory trained regional representatives are available to assist with product recommendations for you projects, and many locations are served by dealers who stock ShoreBest products. Call 800/860-4978 for the name and location of your nearest representative or dealer. |
Home | Products | Cross Reference | Warranty | Company | Projects 800.860.4978 | infoproducts@shorebest.com | © 2003 Shore Corporation |