2418 High Gloss Masonry Sealer - Silane/Siloxane


		Home \| About ShoreBest \| Cross Reference

New Masonry Cleaners	Rest- oration Cleaners	Paint Strippers	Remedial Products	Water Repellents	Environ-mental Products	Concrete Products	EIFS Appearance System

2418 High Gloss Masonry Sealer

2418 High Gloss Masonry Sealer is a high quality waterborne cross linking water repellent based on polyurethane resin technology. It dries to a glossy film which will protect the surface from salt intrusion, water, soda, alcohol, motor oil, dirt, and tannins. This product is UV resistant and has been shown to prevent efflorescence in masonry surfaces, while remaining flexible and allows vapor permeability. 2418 High Gloss Masonry Sealer also has superb mar and scuff resistance for extended protection on old or new concrete.

Preparation & Application

2418 High Gloss Masonry Sealer is normally applied by low pressure, garden-type pump sprayer but it can be applied by roller, brush, or squeegee depending on texture and shape of the substrate. Rough textured placements will require a heavier application rate. For sealing or resealing cured concrete it is strongly suggested to thoroughly clean the surface with a quality cleaner like 2790 Con-D-Soil and pressure washing to remove any dirt, stains, or loose sealer. Allow to dry before applying 2418 at a rate of 150 - 300 square feet per gallon depending on surface texture and desired gloss. Cleanup of tools or equipment can be done with warm soap and water. Dried or partially dried films may require a solvent such as alcohol, acetone, or a glycol ether to remove. Special cleaners for removing latex paints from brushes are available and quite suitable. Mineral spirits is not effective. Drying time is dependent on the ambient temperature and relative humidity. In warm, dry weather allow at least 3-4 hours for light foot traffic and 24 hours for vehicular traffic.

Safety

All applicators must wear standard OSHA or NIOSH recommended protective equipment. 2418 High Gloss Masonry Sealer should not be inhaled or ingested. Keep out of the reach of children. Do not smoke, eat or drink during application. Refer to the proper MSDS Sheet for persons exposed to or reacting to the product.

First Aid

Skin Contact: Flush with soap and water, remove contaminated clothing, thoroughly clean contaminated clothing before reuse. If irritation or rash develops, consult a physician. Eyes: Flush immediately with large quantities of water for 15 minutes while holding eyelids apart. If irritation persists, seek medical attention. Inhalation: Remove to fresh air. Ingestion: Drink large amounts of water. Seek medical attention.

Customer Service & Technical Assistance

Factory personnel can be contacted at 1-412-471-3330 for specific recommendations without any obligation. Factory trained representatives are available in many locations to assist with project recommendations and dealer locations for purchase of materials. Call 1-412-471-3330 for the name and location of your nearest representative or dealer.