2140 Masonry Restorer NA (non-acidic)


		Home \| About ShoreBest \| Cross Reference

New Masonry Cleaners	Rest- oration Cleaners	Paint Strippers	Remedial Products	Water Repellents	Environ-mental Products	Concrete Products	EIFS Appearance System

2140 Masonry Restorer NA

2140 Masonry Restorer NA is a highly effective non-acidic cleaner for limestone, unpolished marble, pre-cast & site cast concrete and concrete block. 2140 Masonry Restorer NA has been used successfully as a one step cleaner for the removal of light to moderate soiling of vertical masonry as well as for the removal of grease & oil deposits, rubber heel marks and certain oxidation stains.

Preparation

Provide protection for foliage and pedestrian traffic. Test all surfaces which might be exposed to product for possible adverse reactions. Protect all surfaces and surrounding areas from possible damage which might occur from spillage or spray during usage.

All projects should start with a test application to determine the suitability of the cleaner, acceptable application method and dilution ratio if applicable. Test areas of at least 10 square feet are recommended and should involve the most severely contaminated condition. When possible, the test area should be left to age for 10 or more says to check for any latent reaction that might require a change in methods or products.

Application

2140 Masonry Restorer NA may be applied by low-pressure spray, synthetic fiber brush or roller. Brush agitation may be helpful on some projects. Dwell times may vary from five to thirty minutes. Do not allow the cleaner to dry on the surface. Removal of the cleaner and contamination can be accomplished with high pressure rinsing equipment. Care should be taken in the selection of the wand tip to avoid damage to the masonry surface. In all cases, a thorough rinsing is required.

Limitations

Masonry Restorer NA is for use by professional contractors only. Projects should not be undertaken when temperatures are below 50 degrees F. Do not allow the cleaner to dry on the surface. Misting of drying cleaner is permissible to avoid possible reapplication. Do not use on polished masonry.

Technical Data

Appearance: Clear Liquid	Solubility: 100%
Biodegradable: Yes	Odor: Mild Citric
Density: 9.1 Lbs/Gal	pH Level: 14 (concentrate)
Emulsification: Excellent	Rinsing: Complete
Flash Point: None	Stability: Good
Foaming: High	Wetting Ability: Excellent
Dilution Ratios are from o to 10 parts water to one part cleaner.

Safety

This product must be used only as directed. Safety matters included with product. MSDS available from your regional representative.

Customer Service & Technical Assistance

Factory personnel can be contacted at 800/860-4978 for specific recommendations without any obligation.

Factory trained regional representatives are available to assist with product recommendations for you projects, and many locations are served by dealers who stock ShoreBest products. Call 800/860-4978 for the name and location of your nearest representative or dealer.