2030 New Masonry Cleaner V/M Control


		Home \| About ShoreBest \| Cross Reference

New Masonry Cleaners	Rest- oration Cleaners	Paint Strippers	Remedial Products	Water Repellents	Environ-mental Products	Concrete Products	EIFS Appearance System

2030 New Masonry Cleaner V/M is a concentrated blend of acids specifically formulated to be used to remove construction dirt and mortar smears from metallic sensitive surfaces containing manganese and vanadium. 2030 should be considered for the cleaning of white, brown, gray and most light colored brick as well as most natural stones, cast stone and some glazed surfaces.

Preparation

Provide protection for foliage and pedestrian traffic. Test all non-masonry surfaces for possible negative reaction. Shut of all ventilation intakes, close all other entrances to the structure and provide protection to ensure that no cleaner or cleaner fumes enter the structure during application or rinsing of the surface. Protect all surrounding areas from possible damage from possible damage that might occur from spillage or spray during usage.

Application

Pre-wet the surface prior to the application of the properly diluted cleaner. Start with the weakest dilution and test until an acceptable dilution is determined for the project. Apply the diluted cleaner with either acid brushes or low-pressure spray. Spray application should never be done at pressures greater than 40 p.s.i. Leave the cleaner on the surface for up to 10 minutes, scrub with a masonry brush if necessary, remove heavy smears with a wood paddle and remove the cleaner and contaminants with either a hose or pressure washer. When using a pressure washer, pressures of 600 to 800 p.s.i. are recommended. Care must be exercised to avoid driving the cleaner into the surface, creating a condition where complete removal is not possible. Avoid using wands equipped with "laser" or other tips that might cause damage to the masonry surface. In all cases, a thorough rinsing is required.

Limitations

2030 New Masonry Cleaner V/M Control is for use by professional contractors only. High strength mortars and mortars left on the surface for more than 60 days may be difficult to remove or may not be removable at all. High strength mortars should be cleaned within 7 days of installation.

Technical Data

Appearance: Dark Liquid	Solubility: 100%
Biodegradable: Yes	Odor: Acidic
Flash Point: None	pH: ‹1 (concentrate)
Foaming: High	Rinsing: Complete
Stability: Good	Wetting Ability: Excellent
Dilution Ratios: 4 to 10 parts water to one part cleaner depending upon conditions and surface.

Safety

This product must be used only as directed. Safety matters included with product. MSDS available from your regional representative.

Customer Service & Technical Assistance

Factory personnel can be contacted at 800/860-4978 for specific recommendations without any obligation.

Factory trained regional representatives are available to assist with product recommendations for you projects, and many locations are served by dealers who stock ShoreBest products. Call 800/860-4978 for the name and location of your nearest representative or dealer.