Preparation
Protect all non-masonry surfaces from dripping or over spray. Provide protection for windows, foliage, adjacent surfaces that are not to receive treatment, vehicle and pedestrian traffic. Take precautions to protect other surfaces from wind drift.
Using the method to be used on the project, apply a test area of 10 square feet to calculate the coverage rate per gallon and to determine if there will be any unacceptable color change. For most dense masonry, coverage rates should be between 75 to 125 square feet per gallon. For split face hollow core concrete block the coverage should be between 50 and 100 square feet per gallon.All masonry surfaces should be clean, surface and subsurface dry prior to application.
Dilution and Coverage
Dilution: Do not dilute this product — test application recommended.
Coverage: Approximately 50 to 100 square feet per gallon — dependent upon substrate and other conditions.
Application
All application equipment must be completely dry before use. A spray application is preferred but roller applications can be success- ful as long as there is complete surface saturation. Spray equip- ment must be clean and equipped with solvent resistant hoses and gaskets. Apply with a coarse low-pressure spray creating a saturat- ing 4 to 6 inch run down of the fluid. Intentional or accidental application to horizontal surfaces like sidewalks or driveways will result in a dangerously slippery situation that must be avoided.
All masonry surfaces must be free of any agent or agents that will prevent penetration of the fluid. Application should not be undertaken when rain is expected within 24 hours or if there is dew, frost or ice in the surface. The best results for OTC VOC 400 products are obtained when surface and ambient temperatures are 55 degrees F and rising. Do not alter the product with any other material. Ulster Flex products are not acceptable for application to horizontal, polished masonry and granite surfaces. If the fluid comes in contact with window glass or other non-masonry
surfaces, remove immediately with a solvent soaked rag. Ulster Flex applications may cause a slight to moderate color enhancement of some surfaces. Testing is recommended, prior to the start of a project, to determine if there are any changes that are unacceptable.
Safety
Flammable liquid and vapor. May be fatal if swallowed and enters airways. Suspected of damaging fertility or the unborn child.Refer to product SDS or product label for hazard statements, precautionary statements and safety information
Warranty
Shore Corporation warrants that this product conforms to the chemical composition described in the Product Label. SHORE CORPORATION EXPRESSLY DISCLAIMS ALL OTHER WARRANTIES, EXPRESSED OR IMPLIED, INCLUDING WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. Shore Corporation shall not be responsible for any direct or consequential damages sustained as a result of the use of this product. Further, Shore Corporation shall not be liable for personal injuries, property damage or any other damages as a result of the use of this product, the sole responsibility of Shore Corporation under the within WARRANTY being the replacement of any nonconforming product. Acceptance and use of this product absolves Shore Corporation from any other such liability whatsoever and from whatever source. The within WARRANTY may not be modified or extended by Shore Corporation representatives or distributors, neither of which are empowered to make any product representation inconsistent with the terms hereof.