Preparation
When applying this product it is recommended to thoroughly clean the surface with a quality cleaner like SB 2790 Con-D-Soil and pressure wash to remove any dirt, stains or loose sealer. Allow surface to dry completely before applying SB 2444.
Provide protection for all surfaces not intended to be treated. Test all areas to determine if there will be any adverse effects. SB 2444 is not visible on most porous surfaces but only a test application will determine if there will be any changes that might be unacceptable. Allow the test area to dry before making a final determination regarding acceptance for your project.
Dilution and Coverage
Dilution: Product used undiluted — test application recommended
Coverage: Approximately 300 to 400 square feet per gallon –dependent upon substrate and other conditions
Application
Apply undiluted SB 2444 to clean, dry surface by low pressure pump sprayer, roller or brush making sure that a thorough saturation of the surface is accomplished. DO NOT ATOMIZE product with a commercial sprayer such as an airless or cup gun HVLP. Coverage on sparingly porous surfaces like slate, granite and marble may be higher. On smooth or polished surfaces like slate, granite, marble or tile, application with a microfiber or lambs wool pad will give a more even application.
For polished surfaces like countertops, use a soft cloth or paper towel to wipe up excess after 15 minutes to avoid darkening the color. If the substrate is very porous and a heavier application is desired, two thinner coats are better than one heavy application. If applying second coat, it must be applied before first coat dries – wet on wet.
Allow SB 2444 to dry until surface no longer has a wet appearance. While the surface will be highly resistant, its oil repellency will increase over the first 4 hours.
SB 2444 is for use by professional contractors only. All masonry surfaces must be free of any material that will prevent penetration of the fluid. Application should not be undertaken when rain is expected within 24 hours or if there is dew, frost or ice on the surface. Do not alter the product with any other material.
Safety
There are no GHS ratings that apply to this product at this time.
Refer to product SDS or product label for hazard statements, precautionary statements and safety information
Warranty
Shore Corporation warrants that this product conforms to the chemical composition described in the Product Label. SHORE CORPORATION EXPRESSLY DISCLAIMS ALL OTHER WARRANTIES, EXPRESSED OR IMPLIED, INCLUDING WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. Shore Corporation shall not be responsible for any direct or consequential damages sustained as a result of the use of this product. Further, Shore Corporation shall not be liable for personal injuries, property damage or any other damages as a result of the use of this product, the sole responsibility of Shore Corporation under the within WARRANTY being the replacement of any nonconforming product. Acceptance and use of this product absolves Shore Corporation from any other such liability whatsoever and from whatever source. The within WARRANTY may not be modified or extended by Shore Corporation representatives or distributors, neither of which are empowered to make any product representation inconsistent with the terms hereof.
