Products for concrete and masonry


SB2180 Hard Surface Cleaner Concentrate

SB 2180 Hard Surface Cleaner Concentrate is a heavy-duty concentrate designed to meet both the demanding needs of industrial and institutional customers as well as maintaining environmental responsibility. It is formulated with the EPA’s DfE listed surfactants and contains no solvents or strong alkalis. It is moderately foaming at ambient and low foaming at elevated use temperatures. It is mildly alkaline and an excellent surface cleaner and degreaser.

For heavy-duty cleaning dilute 5 to 10 parts water to 1 part concentrate. For medium duty use and when used in circulating cleaning/degreasing baths, dilute with 20 to 40 parts water. For light duty cleaning spray and wipe clean, floor scrubber use or use in vehicle cleaning systems, dilute with 50 to 100 parts water to 1 part concentrate.


SB 2180 properly diluted is safe on most surfaces that can be cleaned with water. Concentrated product may reduce gloss on polished marble.

Dilution and Coverage

5 to 10 parts water to 1 part product for heavy-duty
20 to 40 parts water to 1 part product for medium
50 to 100 parts water to 1 part product for light duty Test application is always recommended to determine appropriate dilution rate.

Dependent upon substrate and other conditions


When properly diluted, this product can be used on most substrates not damaged by water. For non-porous surfaces simply apply diluted solution and use mild agitation or brushing to release stubborn soils if necessary and rinse off after a 5 to 15 minutes dwell time. Product diluted in the 50-100 range can be used for cleaning and degreasing VCT and painted flooring. For porous concrete and masonry surfaces, pre-wet the surface with water to both cool the surface and keep the cleaner from soaking in. Lightly scrub heavier soiled areas and rinse with fresh water. For exterior surfaces, pressure washing is recommended but not always required.

SB 2180 is mildly alkaline and, like most detergents, it is slightly irritating to the eyes and skin. Cleaning personnel should wear eye protection and rubber gloves. In case of contact with eyes, rinse with cool water for 15 minutes and get medical attention if irritation persists. Wash skin after contact and launder clothing before reuse. See SDS for detailed information.

Technical Data

  • Appearance: Clear Liquid
  • Biodegradable: Yes
  • Flash Point: None
  • Foaming: Low to Moderate
  • Odor: Mild
  • pH: 11 in Concentrate
  • Rinsing: Complete
  • Solubility: 100%
  • Stability: Good
  • Wetting Ability: Excellent


Causes mild skin irritation. Causes serious eye irritation.
Refer to product SDS or product label for hazard statements, precautionary statements and safety information.


Shore Corporation warrants that this product conforms to the chemical composition described in the Product Label. SHORE CORPORATION EXPRESSLY DISCLAIMS ALL OTHER WARRANTIES, EXPRESSED OR IMPLIED, INCLUDING WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. Shore Corporation shall not be responsible for any direct or consequential damages sustained as a result of the use of this product. Further, Shore Corporation shall not be liable for personal injuries, property damage or any other damages as a result of the use of this product, the sole responsibility of Shore Corporation under the within WARRANTY being the replacement of any nonconforming product. Acceptance and use of this product absolves Shore Corporation from any other such liability whatsoever and from whatever source. The within WARRANTY may not be modified or extended by Shore Corporation representatives or distributors, neither of which are empowered to make any product representation inconsistent with the terms hereof.


Trained representatives are available to assist with project assistance and product recommendations. Call 412/471-3330.

  • This field is for validation purposes and should be left unchanged.