Products for concrete and masonry

SEARCH SOLUTION WIZARD BY

SB2382 CSR Poultice

SB 2382 CSR Poultice is formulated specifically for the removal of deep-seated copper stains from masonry surfaces when mixed with SB 2381 CSR Liquid and, in some cases, with SB 2383 CSR Poultice Additive.SB 2382 is safe for use on most unpolished surfaces. The SB 2382 CSR Poultice is suitable for use on both exterior and interior applications.

Preparation

SB 2382 CSR Poultice is mixed with SB 2381 CSR Liquid to a paste-like consistency that will hang on a vertical surface. Standard plasterers tools and mixing devices are customary for the preparation of the product and application to the surface. Protect all surfaces that are not to receive an application of SB 2382 CSR Poultice. Apply a test sample to the project surface determine the suitability of the cleaner, acceptable application method, thickness and required dwell time to effect the desired cleaning.

Dilution and Coverage

Dilution: N/A product to be combined with liquid to produce a paste — test application recommended

Coverage: Dependent upon substrate and other conditions

Application

Using a broad knife, trowel or other application method, apply a uniform layer of blended SB 2382 CSR Poultice to a thickness of 3/8 to 1/2 inch of product. Application method should ensure that there are no voids that will cause stains to remain in the surface. Before the poultice dries, cover the surface with a lightweight plastic sheet. Avoid air pockets when applying the plastic sheet. Air pockets may allow the poultice to dry pre- maturely. Allow the poultice to remain on the surface for 12 to 48 hours as determined by previous testing. If the poultice is very damp after removal of the plastic sheeting, allow the poultice to dry for several hours prior to removal.Remove the poultice with plastic or wood scrappers, taking care to avoid marring the surface. Remove as much poultice as possible and rinse with high-pressure spray, wet sponges, toweling or soft brushes. All poultice residues must be removed to avoid a film appearing on the surface. Allow the surface to dry and repeat the application where necessary.

SB 2382 CSR Poultice is for use by professional contractors only. Keep out of the reach of children. Application to surfaces that are below 50 degrees F may not react as expected. Usage at temperatures below 70 degrees F may require extended dwell times.SB 2382 can be blended with most other ShoreBest cleaners, except the ones containing hydrofluoric acid or ammonium bifluoride, when extended dwell time and the
drawing/wicking action of the poultice is required.

Technical Data

  • Appearance: Gray Powder
  • Flash Point: None
  • pH: Neutral in Water
  • Stability: Good

Safety


May cause cancer.Refer to product SDS or product label for hazard statements, precautionary statements and safety information

Warranty

Shore Corporation warrants that this product conforms to the chemical composition described in the Product Label. SHORE CORPORATION EXPRESSLY DISCLAIMS ALL OTHER WARRANTIES, EXPRESSED OR IMPLIED, INCLUDING WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. Shore Corporation shall not be responsible for any direct or consequential damages sustained as a result of the use of this product. Further, Shore Corporation shall not be liable for personal injuries, property damage or any other damages as a result of the use of this product, the sole responsibility of Shore Corporation under the within WARRANTY being the replacement of any nonconforming product. Acceptance and use of this product absolves Shore Corporation from any other such liability whatsoever and from whatever source. The within WARRANTY may not be modified or extended by Shore Corporation representatives or distributors, neither of which are empowered to make any product representation inconsistent with the terms hereof.

Contact

Trained representatives are available to assist with project assistance and product recommendations. Call 412/471-3330..

  • This field is for validation purposes and should be left unchanged.