Preparation
Application is to be made to clean, dry and sound surfaces. All containers must be mechanically stirred with a Jiffy Mixer that does not allow for air bubble formation. If colors are in use, box several containers together to avoid possible color varia- tion. Prepare enough material to work from a control joint,expansion joint or corner to avoid possible color changes within a work area that does not have a natural separation point.
Protect any surface that is not to receive the coating from over spray, dripping or other means of exposure to the coating. An on-site application of 5 to 10 square feet of area is recom- mended to check for color and general appearance acceptance. Allow the test area to dry for 24 hours prior to review.
Dilution and Coverage
Dilution: SB 2740 may be “thinned” with up to 20% water to allow for easier application.
Coverage: Dependent upon substrate and other conditions
Application
SB 2740 can be applied by spray, roller or brush using the crosshatch method. If the first coat is applied vertically the second coat must be applied horizontally to provide for an even finished appearance. Two coats are required for any project. Each coat will dry for re-coat within 4 hours at 70 degrees F and 50% humidity. Application of subsequent coats, before the appropriate dry time, can lead to bond failure between the paint films. It is recommended that the first coat be thinned with water and used as a primer coat when application is to an unprimed surface. Clean all equipment with soap and water.
Do not apply to a wet surface or when rain is expected with 12 hours. Minimum application temperature is 50 degrees F surface & ambient and rising. Do not apply to surfaces that are above 95 degrees F. Reseal the container after withdrawing material. Do not use coatings that have been frozen and thawed.
Safety
Suspected of damaging fertility or the unborn child.Refer to product SDS or product label for hazard statements, precautionary statements and safety information
Warranty
Shore Corporation warrants that this product conforms to the chemical composition described in the Product Label. SHORE CORPORATION EXPRESSLY DISCLAIMS ALL OTHER WARRANTIES, EXPRESSED OR IMPLIED, INCLUDING WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. Shore Corporation shall not be responsible for any direct or consequential damages sustained as a result of the use of this product. Further, Shore Corporation shall not be liable for personal injuries, property damage or any other damages as a result of the use of this product, the sole responsibility of Shore Corporation under the within WARRANTY being the replacement of any nonconforming product. Acceptance and use of this product absolves Shore Corporation from any other such liability whatsoever and from whatever source. The within WARRANTY may not be modified or extended by Shore Corporation representatives or distributors, neither of which are empowered to make any product representation inconsistent with the terms hereof.