Products for concrete and masonry

SEARCH SOLUTION WIZARD BY

Download TDS Download SDS

SB2700 Concrete Cleaner

SB 2700 Concrete Cleaner is a highly effective non-acidic cleaner for horizontal concrete and masonry surfaces. SB 2700 can be used to successfully remove light to moderate atmospheric soiling and certain other surface deposits. This product is often used on sidewalks, drive-through areas and parking lots where a non-hazardous labeled cleaning product is an asset. For heavily soiled concrete where conditions permit the use of a stronger product, SB 2790 Con-D-Soil should be considered.

Preparation

Provide protection for foliage and pedestrian traffic. Test all non-masonry surfaces for any possible adverse reactions. Protect all surrounding areas from possible damage, which might occur from spillage or drift during usage.

All projects should start with a test application to determine the suitability of the cleaner and the required dilution ratio.Test areas of at least 10 square feet are recommended and should involve the most severely contaminated location. Allow the test area to dry prior to determining the acceptability of the cleaner and cleaning method.

Dilution and Coverage

Dilution: 0 to 20 parts water to 1 part product — test application recommended.

Coverage: Approximately 150 to 200 square feet per gallon –dependent upon substrate and other conditions.

Application

SB 2700 Concrete Cleaner is most effective when applied by low-pressure spray. Brush application and agitation may prove helpful on some surfaces. Dwell times may vary from 5 to 30 minutes. Removal of the cleaner and contaminant can be accomplished most successfully with a pressure washer. A thorough rinsing is required to avoid a potential slipping hazard when the surface becomes wet from rain or other means. SB 2700 dilution ratios are from 0 to 20 parts water depending upon conditions. Stubborn deposits may require spot treat- ment with either concentrated SB 2700 or another ShoreBest product.

SB 2700 Concrete Cleaner is for use by professional contractors only. Projects should not be undertaken when temperatures are below 50 degrees F. Do not allow the cleaner to dry on the surface. Misting of drying cleaner is permissible to avoid possible reapplication. Do not use on polished masonry.

Technical Data

  • Appearance: Clear Liquid
  • pH: 12.5 in Concentrate
  • Biodegradable: Yes
  • Rinsing: Complete
  • Flash Point: None
  • Solubility: 100%
  • Foaming: High
  • Stability: Good
  • Odor: Mild
  • Wetting Ability: Excellent

Safety


Causes mild skin irritation. Causes serious eye damage.Refer to product SDS or product label for hazard statements, precautionary statements and safety information

Warranty

Shore Corporation warrants that this product conforms to the chemical composition described in the Product Label. SHORE CORPORATION EXPRESSLY DISCLAIMS ALL OTHER WARRANTIES, EXPRESSED OR IMPLIED, INCLUDING WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. Shore Corporation shall not be responsible for any direct or consequential damages sustained as a result of the use of this product. Further, Shore Corporation shall not be liable for personal injuries, property damage or any other damages as a result of the use of this product, the sole responsibility of Shore Corporation under the within WARRANTY being the replacement of any nonconforming product. Acceptance and use of this product absolves Shore Corporation from any other such liability whatsoever and from whatever source. The within WARRANTY may not be modified or extended by Shore Corporation representatives or distributors, neither of which are empowered to make any product representation inconsistent with the terms hereof.

Contact

Trained representatives are available to assist with project assistance and product recommendations. Call 412/471-3330..

  • This field is for validation purposes and should be left unchanged.